Porter Cable FC350B Manuel D'instructions page 6

Use of this product may expose you to chemicals known to the State
of California to cause cancer, birth defects and other reproductive harm. Avoid inhaling
vapors and dust, and wash hands after using.
• Avoid prolonged contact with dust from power sanding, sawing,
grinding, drilling, and other construction activities. Wear protective
clothing and wash exposed areas with soap and water. Allowing dust
to get into your mouth, eyes, or lay on the skin may promote absorption of
harmful chemicals.
Use of this tool can generate and/or disburse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved
respiratory protection appropriate for the dust exposure. Direct particles away from
face and body. Always operate tool in well-ventilated area and provide for proper dust
removal. Use dust collection system wherever possible.
ALWAYS USE SAFETY GLASSES. Everyday eyeglasses are NOT safety
glasses. Also use face or dust mask if operation is dusty. ALWAYS WEAR CERTIFIED
SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA respiratory protection.
Before operating this tool, carefully read and understand all instructions in
Important Safety Instructions.
nails
lengths
Angle
Air Inlet
nOTe: Use only pORTeR-CABle approved fasteners
save these instructions
nAIl SpeCIFICATIOnS
0.113"–131" (2.87–3.33 mm) diameter, papertape
collated clipped head framing nails
2"–3-1/2" (50–90 mm)
1/4" NPT (6.4 mm)
6 - ENG
FC350B
34º