Thermador TCM24RS Manuel D'utilisation page 23

en
● Press A� "Save changes?"
appears�
● Press the M arrow button� The setting
is saved�
The drink selection appears on the display�
Note:
Press A to exit the menu at any
time� If no entry is made within approx�
30 seconds, the menu closes automatically
and the settings are not saved�
The following settings can be made:
Language
Set the desired language to show the
display texts�
Water hardness
Set this to the local water hardness�
Level "1 (soft)" to "4 (very hard)" can be
selected� The preset water hardness is
"4 (very hard)"�
Note:
It is important to set the water hardness
correctly to enable the appliance to accu-
rately indicate when the descaling program
should be run�
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier� If a water softening
system is installed in the house, please
select the "Softening device" setting�
Water filter
If a water filter is inserted, renewed or
removed, the setting "Activate", "Replace" or
"Remove" must be made in the menu�
Note:
A water filter lowers limescale deposits,
reduces impurities in water and improves
the coffee taste�
Water filters are available from retail outlets
or from customer service (see the section
"Accessories")�
Inserting or renewing a water filter:
A new water filter must be rinsed before it
can be used�
● Select either "Activate" or "Replace" with
the K or L arrow button�
● Press the water filter firmly into the
opening of the water tank�
● Fill the water tank with cool water up to
the "max" mark�
● Remove the milk tube from the milk
container and close the door�
NOTICE:
Do not jam the tube when closing the door�
● Place a container with a capacity of
0�5 liter under the outlet �
● Press C�
Water will now flow through the filter to
rinse it�
● Then empty the container�
The appliance is ready for use again�
Note:
Rinsing the filter simultaneously activates
the setting for the change filter display�
The filter is no longer effective when the
"Replace water filter" display appears, or at
the latest after two months� It needs to be
replaced for reasons of sanitation and to
prevent a build-up of limescale (which could
damage the appliance)�
● If a new filter is not inserted, select
the setting "Remove" and press button
C�
The message "Remove filter, reinsert
water tank, close door" appears�
19