Troubleshooting - Zanussi ZDH8333P Notice D'utilisation

CAUTION!
Do not use furniture cleaning agents
or cleaning agents which can cause
corrosion to clean the appliance.

Troubleshooting

You cannot activate the appliance.
The programme does not start.
The appliance door does not close.
The appliance stops during operation.
The display shows a long programme duration.
The display shows a short programme duration.
The display shows Err.
The display shows (e.g. E51).
1) After maximum 5 hours, the programme ends automatically
If the drying results are not satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.
• There was too much laundry in the
appliance.
28
Problem
Cleaning the airflow slots
Use a vacuum cleaner to remove the fluff from
the airflow slots.
Make sure that the mains plug is connected to the
mains socket.
Check fuse in fuse box (domestic installation).
Press Start/Pause.
Make sure that the appliance door is closed.
Make sure that the installation of the filter is cor-
rect.
Make sure that the laundry does not catch between
the appliance door and the rubber seal.
Make sure that the water container is empty. Press
Start/Pause to start the programme again.
Make sure that the weight of the laundry is applica-
1)
ble to the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in the
washing machine again.
Make sure that the room temperature is not too
warm.
Set the Time Drying or the Extra Dry programme.
If you want to set a new programme, deactivate
and activate the appliance.
Make sure that the options are applicable to the
programme.
Deactivate and activate the appliance. Start a new
programme. If the problem occurs again, contact
the Service.
• The drum is dirty.
• Incorrect setting of the conductivity sensor.
• The airflow slots are clogged.
Possible solution
www.zanussi.com