Changing The Batteries - Geberit SIGMA10 Mode D'emploi

EN
Maintenance
Maintenance regulations for Sigma10
If power is supplied to the Geberit WC flush control via batteries, these must be replaced
approximately every 2 years.

Changing the batteries

Prerequisite
– 2 replacement batteries (type 1.5 V
mono/D/LR20/AM-1, recommendation:
Varta Industrial or Panasonic Powerline)
are available.
– WC lid is closed.
Loosen any screws that may be
present on both sides of the actuator
plate.
1
Remove the actuator plate.
16
2
Disconnect the power supply cable
from the control.
3
Remove the battery compartment
cover.
9007203698350091-1 © 07-2019
966.230.00.0(03)