Geberit SIGMA10 Mode D'emploi page 13

Operation
Using Geberit Sigma10
▶
To release a flush, place your hand
in the detection range (approx.
15 cm) in front of the actuator plate.
There is no need to touch the
actuator plate. Place your hand in the
detection range for approx. 0.5–1
second for a large flush and for
approx. 1–2 seconds for a small
flush.
9007203698350091-1 © 07-2019
966.230.00.0(03)
Deactivating automatic flush
actuation
The preset automatic flush actuation can be
deactivated at any time.
The procedure for activating
automatic flush actuation is the same
as for deactivating it. 5 single tones
will sound to indicate acoustically
that automatic flush actuation has
been activated successfully.
Prerequisite
– The WC flush control is ready for
operation.
Loosen any screws that may be
present on both sides of the actuator
plate.
EN
13