Zepter EdelWasser PWC-670-BLACK Mode D'emploi page 8

EN
Installation of outlet tubing (blue)
ATTENTION
Plumbing and carpentering work is needed
Ensure, whether the main water supply is turned off before any
plumbing work is started.
Following installation can be use in case when the customer prefer to
connect outlet tube for waste water to the drain under the sink.
1. Cut a square 16x25mm in the kitchen desk
(if is needed) and put the blue outlet tube trough.
2. Use the "drain clamp" for better outlet tube
fixing.
3. Drill the hole 6.5 – 7 mm in to drain pipe
4. Insert the blue tube in to upper part of the clamp (blue outlet tube should
be inserted inside of the drain pipe) and screw the clamp together
5. Verify whether all connections fit
properly and water does not leak.
• After installing the product
Get rid of the saved water above the full water in the inner water tank 2
times or more to use.
• When you haven't used for a long time
If you saved the water for a long time or you didn't use, drain the water
inside of the water filtration device completely and remove the newly
filtered water one time to use.
• Regular filter replacement
It is important to replace the filter regularly to maintain water quality as it is
designed. If the filter is overused beyond its service life, the performance of
the water filtration device deteriorate. Do not miss the filter replacement cycle.
Tip
When you aren't going to use Edel Wasser for a long time, close the main
water supply valve.
EN
13