Zepter EdelWasser PWC-670-BLACK Mode D'emploi page 6

EN
Be cautious!
• Water filtration device installation place 1
Please install the water filtration system not at a
rough place, a damp place, a place where the
unit is exposed to the direct sunlight, a place
where dust is present, or a place that the water
drops.
• Water filtration device installation place 2
Please install at the place where it is 10 cm or
more off from the wall and the bottom is flat and
firm.
• After installing the water filtration
system
Please empty the water tank filled with filtered
water two times after the product installation.
• Cold water plumbing
Please connect the source water. Make sure that
the source water is not from hot water line.
If you use hot water as source water, then it will
cause permanent damages to RO membrane and
severely degrade the product performance.
• Filters installation
NEO-SENSE Filter, RO MEMBRANE Filter and INNO-SENSE
Filter are already installed inside of the device
To install Hygienic filter follow next steps:
1) Please remove the top cover, and then un-hook the fixed clip holding the
top cover of the water tank. Now open the tank cover.
➋
➊
2) Unpack the Hygienic filter from foil.
3) Apply the Hygienic filter on the water tank cover.
4) Close the water tank cover and assemble the fixing clip.
Tips
- There may be some water remaining inside of the filter which was used to test
the product during inspection process at the factory.
Please feel at ease and use as it isn't a used product.
- Don't reuse the main water supply valve and hose that was previously used
when you re-install the product.
- System and installation shall comply with local laws and regulations.
EN
9