Machine Storage; Safety Notes - Jimmy JV71 Manuel D'instructions

Deep clean dust cup
1.Press dust cup release button, remove dust
cup assemlby from handheld vacuum.
Dust cup release
button
Mainbody
Dust cup
2.Pull out cyclone from dust cup and dump the
.
dust on dust cup
Cyclone assembly
Dust cup
3.Remove HEPA from cyclone to clean or
replace. Cyclone can be washed and use after
drying.
HEPA
Cyclone
Clean mainbody dust cup
Rotate mainbdy dust cup anticlockwise until
the point on dust cup aligns with the unlock
mark on mainbody. Remove and empty dust
cup. Rotate cyclone anticlockwise, remove
and clean the cyclone. Assemble the cyclone
and dust cup back into mainbody in opposite
sequence.
Mainbody dust cup
Cyclone
Clean Brushroll
1.Slide brushroll cover latch backward
Brushroll cover latch
2.Remove brushroll right cover
Brushroll right cover
3.Take out brushroll and clean it.
Brushroll
6
Clean nozzle hose
1.Push the two nozzle base cover latches
towards middle and release nozzle base
cover.
Nozzle base cover slide

Machine Storage

Store the machine in cool and dry place, avoid direct sunlight or humid environment.

Safety Notes

Warning! Read all safety warnings and all instructions before use. Failure to follow the
warnings and instructions may result in injury.
This vacuum cleaner is designed for home use. Do not use it for commercial or other purposes.
1.Do not use the vacuum to pick up detergent, oil, glass slag, needle, cigarette ash, wet dust,
water, matches, etc.
2. Do not use the vacuum to pick up tiny particles such as cement, gypsum powder, wall powder,
or large objects such as paper balls, otherwise it will cause malfunctions such as blockage and
motor burnout.
3. Do not put the vacuum close to fire or other high temperature facility.
4.When using the vacuum, make sure HEPA and brush roll are assembled, otherwise, it may lead
to motor fan blockage, causing motor burn out.
5.Avoid blockage to air inlet or brushroll, it may cause motor failure.
6.Do not pour or splash water or other liquids into the machine to avoid short circuit to burn out
the machine.
7. Fully charge the battery before first use or after long storage. When storing the unit for a long
time, ensure that the battery is fully charged before storage and charge the machine at least
every three months.
8. Unplug the charger to clean or repair the machine. Hold the charger when plugging or
unplugging it, and do not pull the charging cord.
2. Remove nozzle base cover and pull out
hose to clean or replace. Assemble in opposite
sequence.
Hose connector
Nozzle base cover
7