Product Operation - Jimmy JV71 Manuel D'instructions

Aspirateur
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18

Product Operation

Charging
Charge the vacuum cleaner in time when
battery power is insufficient; When the
voltage is too low, to protect the battery, the
vacuum will automatically turn off. At this
time, the vacuum must be charged. Before
charging, ensure that the hand-held vacuum
is installed into mainbody. Then place the
upright machine onto the charging base, plug
the charger, and the charging indicator turns
red. The vacuum cleaner is charging.
Note: When using for the first time, fully
charge the battery and fully discharge the
battery before second charge to increase the
battery life.
When the charging indicator on the hand-
held vacuum turns from red to green, it
means the vacuum cleaner is fully charged.
We recommend continue charging for half an
hour to the hour, so that the charging effect
is better. Charging time is about 4 hours. After
charging, unplug the charger to stop charging.
Power indicator
Power socket
Use of upright vacuum
Remove the vacuum from the charging base,
press the on/off button on handle to turn on
and turn off the vacuum. Power indicator on
handheld will turn green when the machine
works. The mode control button on handle
can switch between strong mode and normal
mode.
On/off button
Mode control button
Power indicator
Use of handheld vacuum
Remove the handheld vacuum from the
charging base, press the on/off button to turn
on and turn off the vacuum. Power indicator
will turn green when the machine works. The
mode control button can switch between
strong mode and normal mode.
Power indicator
On/off button
Mode control button
Use of electric floorhead
Electric floorhead can clean short hair carpet 、
hardfloor or tile floor.
Note:When the electric floorhead is running,
if brushroll stopped running due to big foreign
object blockage or excessive fiber entangle,
or the child accidentally putting hand into
brushroll, the floorhead will stop working to
protect personal safety and avoid damage to
floorhead motor.
4
Use of tools
1.2-in-1 upholstery tool: Suitable to clean
dust on closet 、 windowsill 、 sofa and table
surface.
2.2-in-1 crevice tool: Suitable to clean crevices,
corners andother narrow areas.
3.Electric Mattress Head: Beat up and clean
dust 、 dust mite and dust mite allergen from
sofa and bed
4.Dusting brush: Connect with handle to clean
top areas like roof 、 curtain 、 air conditioner
vent etc.
5.Stretch hose: Connect between handheld
vacuum and tools to clean hard to reach places.
Reinigung
Note:It is recommended to clean the dust cup
after each use; When the dust cup is full or the
HEPA filter is clogged, it needs to be cleaned
and replaced if necessary. Floorhead brushroll
might be entangled with hair after long use, it
needs to be cleaned in time to keep the vacuum
working more efficiently.
Clean dust cup and filter
Clean dust cup
Press dust cup bottom release button and
bottom cover will open to dump dust in dust
cup.
B o tt o m r e l e a s e
button
5

Publicité

Table des Matières
loading

Table des Matières