Power Off; Channel Reverse - RocHobby Fire Horse Mode D'emploi

EN

Power Off

Follow the steps below to turn off the system:
1. Disconnect the receiver power.
2. Toggle the transmitter's power switch to the off position.
Channel Description
The transmitter outputs a total of 4 channels, which are allocated as follows:
• CH1：Steering Wheel
• CH2：Throttle Trigger
• CH3：Three-position Switch
• CH4：Key Switch
Note: By default the output of CH4 is 1000us, after which pressing the button will toggle between 1000 and 2000us.

Channel Reverse

This function is used to adjust the action direction of the servo or motor
The ST.REV / TH.REV switches are the reverse buttons for CH1 and CH2. If the switch is up it indicates reverse, and
the down indicates normal.
Trims
The ST.TRIM is the trims for CH1 (steering ),and can be multiplexed as Trims of CH3 ;
The TH.TRIM is the trims for CH2（throttle).and can be multiplexed as Trims of CH4 ;
For multiplexing switching mode, see [5.5 Mode Switching].
Adjustment range: -120us- + 120us;
ST.TRIM/TH.TRIM: counterclockwise adjustment to increase the trim value. The maximum value is 120 us.
ST.TRIM- / TH.TRIM-: clockwise adjustment to decrease the trim value. The minimum value is -120 us.
D/R
The ST.D/R is the trims for CH1 (steering ),and can be multiplexed as Trims of CH3 ;
The ST.D/R is the trims for CH2（throttle).and can be multiplexed as Trims of CH4 ;
For multiplexing switching mode, see [5.5 Mode Switching].
Adjustment range: 0-120%;
ST.D/R: counterclockwise adjustment to increase the ser vo amount . The maximum value is 120%.
ST.D/R: clockwise adjustment to decrease the ser vo amount . The minimum value is 0%.
TH.D/R: counterclockwise adjustment to increase the servo amount. The maximum value is 120%.
TH.D/R: clockwise adjustment to decrease the servo amount. The minimum value is 0%.
Mode switching
This function is for reusing the ST.TRIM and ST.D / R buttons for different channels
Function setting:
Under normal power-on condition, press the BIND button twice (within 1S) to switch between mode 1 and mode 2.
By default, mode 1 is used.
Mode 1: R.LED is always on. G.LED is off. ST.TRIM is for CH1 trim. ST.D/R is for CH1 ser vo adjustment . TH.TRIM is for
CH2 throttle trim. TH.D/R is for CH2 throttle ser vo adjustment .
Mode 2: R.LED and G.LED are flashing alternately. ST.TRIM is for CH3 trim. ST.D/R is for CH3 ser vo adjustment .
TH.TRIM is for CH4 trim. TH.D/R is for CH4 ser vo adjustment .
05
Note
Make sure to disconnect the receiver power
before turning off the transmitter. Failureto
do so may lead to damage or serious injury.