Dirna Bycool green line DINAMIC 1.1 Manuel De L'utilisateur page 7

DINAMIC 1.1
TO DISABLE REMOTE CONTROL
- In order to erase any programmed control, continuously press the
then press the
C
shows
All activated controls are automatically cancelled (do not wait more than 30 seconds between
pressing one key and the other or equipment will be switched off).
ca will appear on display. alternatively whith the selected temperature. If temperature is
above 32º inside vehicle, when equipment is switched on, blower and compressor go into
maximum power for about 20 minutes, then blower and compressor regulate their capacity
depending on inside temperature.
By pushing , one key or the other, desired temperature is chosen, between 15º
and 27º.
With this function, compressor goes into maximum power with minimum air speed.
Compressor is activated or desactivated according to temperature selected on display.
By maintaining
display. Release on desired speed.
By maintaining
display. Release on desired speed.
By pushing only once, one key or the other, desired temperature is chosen, between
15º and 27º.
Compressor and electro are automatically connected and disconnected when reaching
chosen temperature. (Ex. chosen temperature 23º, compressor and electro are disconnected
at 21º and are reconnected at 24º).
It indicates temperature inside vehicle. In this functioning mode, equipment is switched off.
key.
F4 Automatic functioning
F0 Manual functioning
, pushed, blower speed increases and U1, U2, U3, U4, U5 appear on
, pushed, blower speed decreases and U1, U2, U3, U4, U5 appear on
F1 Digital thermometer module
7
dirna
, s.a.
EN
plate key until display