First Steps; First Time Installation; Manual Start - Xoro HRT 1285 Manuel D'emploi

First time installation

After all connections have been made properly,
switch on TV and make sure the receiver is
connected to the Main Power. Press Power
button to switch receiver on.
If you are using the receiver for the first time or
restored to Factory Default, the Main Menu will
appear on your TV screen.
1. OSD Language: Choose your language
and country
2. Start channel searching with
channels found channels are saved in the
channel list
3. If the TV settings are not correct press MENU
and choose Digital TV -> Configuration -> TV
4. Choose the aspect ratio according to your TV
(16:9 / 4:3)
5. If you connected the HRT 1285 via SCART
choose RGB in „Video output". Otherwise
choose CVBS
6. If you use HDMI choose 576i
7. Leave the settings with EXIT´

Manual Start

If the first time installation does not start you have to start the channel searching
manually.
1. Restore factory defaults (MENU -> Digital TV
-> Factory Defaults)
2. After restoring the factory defaults go to
Configuration -> System Setup
3. Choose the correct country in the „Area"
menu.
4. Navigate to the „Digital TV" (EXIT) menu and
choose „Installation"
5. The channel search begins by activating
„Auto Search"
16

First Steps

OK. The
HRT 1285