Publicité
Les langues disponibles
Les langues disponibles
smart
GENERAL INSTALLATION
Only once you are completely satisfied that your Smart Flap works with all your cats' microchip, prepare to install your Smart Flap.
Installation into:
1.
Non-glass door
2.
Glass door or window
3.
Wall (only possible with specified Smart Flap models – check base of box for model type)
General considerations for all installations:
Before positioning the Smart Flap it is important to consider the following points.
a)
If fitted into a door: Will any of the components of the Smart Flap be obstructed by the door opening and closing?
b)
If fitted into a wall: Are there any objects such as doors that could open on to the Smart Flap once it is fitted?
c)
Where is the closest power point?
d)
Battery operation alone.
e)
Extension tunnels for doors over 52 mm thick and walls.
f)
Is there a large step down from your door?
g)
If there is an existing opening in your door, is it greater than 212 mm diameter if circular or 169 mm by 169 mm if rectangular?
Power Supply
Your Smart Flap is supplied with a low voltage power supply that has a 2.5m electrical cable. If your nearest power point is more than
2.2m away then you will require an extension cable which is available to purchase online at www.petporte.com
Battery operation
For reliable and fast operation we recommend the use of the external power supply with the Smart Flap. However an optional 9V PP3
battery may be plugged in so that during power cuts your cat will still be able to use the cat flap. We recommend the use of a good
quality non-rechargeable lithium battery in order to give the longest battery life. Please note that there are certain options that are not
available when the Smart Flap is powered by batteries:
1)
Automatic Night Mode
2)
Wall Installations
When the Smart Flap is being powered by the external power supply, the scanner is scanning all the time for your cat's microchip and
therefore will normally register and unlock the cat flap before your cat is at the transparent door. When using batteries, your cat will
need to push the transparent flap in order to activate the microchip scanner. If your cat just sits outside the cat flap then it will not
activate the scanner and will not allow access.
Extension tunnels
Please note that the Smart Flap comes with an extension tunnel to fit doors up to 52mm thick. If your installation requires a tunnel longer
than this then extra tunnel sections, each providing 47mm of additional length, are available at www.petporte.com. Tunnels can be
stacked together by glueing and pushing them together.
flap
Installation Guide - Page 2
Publicité
