Getting Started; Filling The Reservoir - Waterpik 500 Serie Mode D'emploi

6

GETTING STARTED

Fill
Eject
Pressure
Seting
2.
1.
Remove
Charging Unit Prior to First Use
Plug the power cord into the wall and place the magnetic charger on the front
of the unit for approximately 4 hours (see image). The charge indicator on
the handle will flash when charging and will stay on continuously when the
unit is fully charged. A full charge will last for approximately 1 week of typical
use. When the batteries are in need of charging (approximately 30% charge
left) the charge indicator light will blink 8 times quickly after use to indicate
that you should recharge the unit. A complete recharge will take 3-4 hours.
If you use your Water Flosser once a day or less, it is recommended you
charge it once a week. If you use it twice a day or more, charge the unit more
frequently.

Filling the Reservoir

Remove the magnetic charger from the unit prior to filling reservoir and
product use. Lift flip top on reservoir and fill the reservoir with lukewarm
water.
Inserting and Remove Tips
Insert tip into the center of the knob at the top of the Water Flosser handle.
Press firmly until the tip clicks into place. To remove the tip from the handle,
press the tip eject button and pull tip from the handle.
CAUTION: Do not press tip eject button while unit is running.
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water Flosser by pressing the
mode button on the handle. Start with the lowest setting and increase to your
liking.
Recommended Technique
Lean low over sink and place tip in mouth. Aim the tip toward gumline,
and turn the unit ON (I).
For best results, start with the back teeth and work toward the front teeth.
Glide tip along gumline and pause briefly between teeth. Continue until you
have cleaned the inside and outside of both the upper and lower teeth.
Direct the jet stream at a 90-degree angle to your gumline. Slightly close
lips to avoid splashing but allow water to flow freely from mouth into
the sink.
Keep unit upright during use for best results.
When Finished
Turn the unit off. Empty any liquid left in the reservoir.
If desired, the reservoir may be removed from the power handle by sliding
the reservoir release latch to the unlock position(1) sliding the reservoir
release latch to the unlock position and then (2) sliding the reservoir down
toward the base of the unit.