Hinkley VAIL Mode D'emploi page 13

INSTALLING THE LED ASSEMBLY AND LIGHT COVER
Wire connectors
LED
assembly
Light Cover
Fig. 1
Remove one of the three screws on the mounting hub
1
located on the fan motor. (Fig. 1)
2 While holding the LED assembly under your fan, make the
polarized plug connections: (Fig. 1)
- Red to white
- Black to black
NOTE: If you do not plan to install the LED light kit with your
fan at this time, don't make the wire connections.
Remove the screws and take out the glass board form the
light cover (Fig. 2), then attach the metal cover to the light
cover B and light cover A with the screws provided. (Fig. 3)
Mounting Hub
(bottom of motor)
Screws
5
Light
Cover A
Glass
Board
Light
Cover B
Fig. 2
Light
Cover A
Metal
Cover
Light
Cover B
Fig. 3
Tuck connections neatly into LED assembly, place the LED
3
assembly to the mounting hub with 3 screws provided. (Fig. 1)
Raise the light cover against the LED assembly and turn
4
clockwise until snug, DO NOT OVERTIGHTEN. (Fig. 1)
Restore power and your light kit is ready for operation.
5
©2019 Hinkley Lighting, Inc. | hinkley.com |
Screws
Screws
11