Diloc D.ETERNITY9 Mode D'emploi page 98

How To Use The Advanced Functions
ON/OFF
MODE
TEMP
FAN
SLEEP SWING
TURBO LED
CLEAN
Model: RG57A7(B)/BGEF
FOLLOW ME function
The FOLLOW ME function enables the
remote control to measure the temper-
ature at its current location. When using
AUTO, COOL, or HEAT functions,
measuring ambient temperature from
the remote control (instead of from the
indoor unit itself) will enable the air
conditioner to optimize the temperature
around you and ensure maximum comfort.
1. Press FOLLOW ME button to activate
function. The remote control will send
temperature signal to the indoor unit
every three minutes.
2. Press FOLLOW ME button again to
turn off this function.
Page 15
 
TIMER
ON
TIMER
OFF
DIRECT
FOLLOW
ECO function
Used to enter the energy efficient mode.
Under cooling mode, press this button, the
remote controller will adjust the temperature
automatically to 24 C, fan speed of Auto to
save energy(but only if the set temperature
O
is less than 24 C). If the set temperature is
O
above 24 C , press the ECO button, the fan
speed will change to Auto, the set temperature
will remain unchanged.
NOTE:
Pressing the ECO button, or modifying the
mode or adjusting the set temperature to
O
less than 24 C will stop ECO operation.
Under ECO operation, the set temperature
O
should be 24 C or more. it may result in
insufficient cooling. If you feel uncomfortable,
just press the ECO button again to stop it.
SWING function
Swing Button
Used to stop or start horizontal louver auto
swing feature.
DIRECT Button
(not applicable to model RG57K7(B)BGEF)
Used to set the desired up/down air flow
direction. The louver changes 6 degree in
angle for each press.
O