EA NSX 1500 Notice D'utilisation page 18

Notice d'utilisation: NSX 1500 Table de mixage 3+1 canaux
14. On/Off (ON AIR) switch for the DJ MIC (MIC1) microphone.
15. Input level meter for display of the input signal level.
16. Input selector for stereo channels. Switches between the inputs as
indicated on the front panel. A LED indicates the pressed position.
17. Gain control of input channels. Allows adjustment of the input sensitivity to
compensate for different source volumes. To facilitate proper setting of input
gain levels, the stereo inputs INPUT1/2/3/4 feature a 10-LED level meter.
18. CUE switch for stereo channels. Assigns the respective channel to the
headphone bus for pre-fader-listening (CUE). A LED indicates the pressed
position.
19. Channel fader for input channels. A high-grade dual rail 60mm fader
determines the volume of the respective channel.
20. Crossfader. A high-grade dual rail 45mm fader determines the mix ratio
between the stereo signals of channel 1 and channel 3.
21. Crossfader Curve switch. Allows the transition characteristic of the
crossfader between the CH1 and CH3 signal to be switches between smooth
a flat and steep mixing curve.
22. Headphones output. A ¼" TRS connector to connect a headphone. Turn the
CUE level (25) down before plugging in any headphones.
23. CUE Mode switch. This control offers two pre-listening modes: (A) Split. In
this mode, the master signal appears on one earcup of the headphones, the
CUE signal on the other earcup. (B) Blend. In this mode, main and CUE signal
are mixed with adjustable ration by means of control (24). A LED indicates the
pressed position.
24. CUE Mix control. If the CUE mode (23) is set to "BLEND", the headphone
signal can be a mix of the main output and the input(s) assigned to the CUE
bus by means of switches (18). This control determines the mix ration
between the main and the CUE signal.
25. CUE volume. Determines the signal volume at the headphone output (22).
Always set this control to minimum before putting on headphones, as sudden
high-volume impact may damage your ears. See further health advice below.
26. Output level control. Determines the main output level present at outputs (3)
and (4).
27. Booth level control. Determines the booth output level present at output (5).
28. Output level meter. Displays the output level at outputs (3) and (4).
■ Connections
For connecting this unit to AC mains, please note:

Check whether the AC mains voltage and frequency is the same as this
product is specified for (see rear panel of product). Whenever the specified
voltage or your AC plug should not match the local conditions, do NOT plug
the AC cord into the wall outlet and contact you dealer immediately.

Do not operate this unit without the line cord earth ground connected. To do
so may increase the risk of electric shock and increase line cord conducted
emissions.
18