Standalone Mode - Rosco Beyond RK350DT Instructions D'installation

9. Perform a walk test (see Step 7).
10. Insert and fasten the screw to lock the detector (see Figure 5).
Step 3: Coverage
PIR Coverage
Mounting height [m]
1.8
2.2 (optimal)
Note For pet immunity, install the detector at the optimal height of 2.2 meters.
PIR Coverage - Using Swivel
Note The table below is relevant when using the Swivel/Solar Swivel Bracket (Model: RA350S).
Mounting height [m]
1.8
2.2 (optimal)
2.5 – 2.7
NA = Avoid such installation
Step 4: Setting Detector Mode

Standalone Mode

1. DIP SW 6 is OFF
2. Terminal wiring as in Step 5a
RISCO BUS Mode
1. DIP SW 6 is ON
2. Wiring:
a) + - terminal  Detector 12 VDC, - GND
b) Connecting YEL / GRN – Detector BUS
c) Continue to step 6
Step 5a: Connecting the Terminal Wiring (Standalone Mode)
Connect the terminal wiring according to the following:
Distance [m]
10
12
Swivel Angle [°]
0
5
10
0
5
10
0
5
10
Distance [m]
10
7
5
12
8
6
N/A
10
7
4