wodtke FT 1 Mode D'emploi page 79

Press upper button ( button disables the RF signal) to enable an continous RF signal. The receiver
+ –
LED will go out as soon as a signal from the transmitter is received. Then press the -button, the
OK
radio link between transmitter and receiver is now established. Press the -button to return to Auto
ESC
mode.
Receiver: When operating in heating mode and an ON signal is received, the LED illuminates
continously. When an OFF signal is received, the LED is off (and flashes periodically at longer
intervals). Is no valid radio signal received from the transmitter for more than one hour (e.g. low
battery) the emergency operating mode will be activated. The LED flashes every 0,5 seconds.
79
EN