Extension Cords; Loading Tool - Desa Powerfast PEBNS11/4-B Mode D'emploi

All manuals and user guides at all-guides.com

Extension Cords

CAUTION: Use only extension cords marked for outdoor use.
WARNING: Inspect extension cords often and replace if damaged.
Be sure to use the right size extension cord. If cord size is wrong, tool may be
damaged. Tool performance may also be affected.
Extension Cord Size Requirement
1 to 25 feet, use 16 AWG rated cord
26 to 50 feet, use 14 AWG rated cord

Loading Tool

WARNING: Never load tool while it is plugged in. Accidental
discharge may occur. Before loading, toggle power switch to the
OFF (0) position and unplug tool.
1. Toggle power switch to the OFF
(0) position (see Figure 1) and
unplug tool.
2. Press in latch lock and slide
magazine back until fully open
(see Figure 2).
3. Lay tool on its side with view window
facing upward (see Figure 3).
4. Load staples/nails on track (see
Figure 3). Make sure staples/nails
are forward in the magazine and
staple/nail points are toward bot-
tom of tool.
Figure 1
116261
Magazine
ON/OFF
Switch In
Off Position
5
Latch Lock
Figure 2
View Window
Loaded Staples (Shown)/Nails
(Points Toward Bottom of Tool)
Figure 3
www.desatech.com
Continued