Cequent Towing Products 36296 Instructions D'installation

Plastic
Fascia
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: F36296
Wrenches: 18mm, 19mm
Drill Bits: None
1
M12 X 1.75 Stud
Shown in Position
1
Qty. (2) Stud – M12 x 1.75
2
Qty. (2) Spacer – 3/16 x 1-1/2 x 2
1. Remove only the front bumper bolts, both sides.
2. Install the M12 X 1.75 stud into position, until seated to frame, where bumper bolt was removed, both sides. Final tightening will
occur when nuts are tightened.
3. Remove rear bumper bolts and place hitch into position as shown.
4. Install remaining fasteners.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2001, 2004, 2007 Cequent Towing Products
Installation Instructions
Chrysler Town & Country
(Fits all models 2WD, 4WD,
Short & Long Wheel Base)
Drawbar Kit:
Drawbar must be used in the
RISE position only.
Frame rail
Frame rail
1
2
3
4
Tighten all M12 x 1.75 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Chrysler Voyager
Dodge Caravan
Plymouth Voyager
Do Not Exceed Lower of Towing Vehicle
36071
3500 LB (1589 Kg.) Max Gross Trailer Weight
300 LB (136 Kg.) Max Tongue Weight
Wiring Access Location: SUV1, SUV2
1
2
3
4
Bumper
Bracket
Existing M12
Fastener
3
Qty. (2)
4
Qty. (2)
Sheet 1 of 3
Manufacturer's Rating or
Bumper
Bracket
Install this end
Into vehicle frame
Hitch attachment
To this end
Lock Washer – ½"
Hex Nut – M12 x 1.75
N36296 3-7-07
Part Numbers:
36296
06369
90165
39602
1
M12 X 1.75 Stud
Rev. D
Form F206 Rev A 5605