Foppapedretti MYDRIVE Instructions De Montage page 30

Insert the belt into the red and blue
Step 3:
locking device (see point 2.8). Insert the lap belt
into the belt loop (group 1).
Step 5: Place your child in the car seat and fasten the
harness, ensuring that it is not twisted.
IMPORTANT: The reclined positions (1, 2 and 3) are only
suitable when the car seat is forward-facing. The adjustment
can be carried out before or after installation.
• ENGLISH •
INSTALLING THE CAR SEAT
Pull out the vehicle's seat belt (diagonal and
Step 2:
lap belt) and insert it through the belt loop in the
backrest. Clip in the seat belt buckle. A "click" will
indicate that it is attached correctly.
Insert the lap belt into the belt loop (group
Step 4:
1) on the opposite side.
Tighten the belt to the maximum, by pulling it in
the direction of the red arrow, first on the lap area
then on the diagonal area. If necessary, push down
the locking device lever, let the belt slide, and then
release the lever. Make sure that the belt is not
twisted and that it fits tightly.
30