i-tec C31DUALKVMDOCKPD Mode D'emploi page 12

i-tec USB-C Dual DP Display Dock with PD 65W/100W
HARDWARE INSTALLATION (CONNECTING THE DOCKING STATION
TO THE LAPTOP/TABLET)
1) Turn on your laptop/tablet and connect the power adapter to the
docking station.
2) (Optional) Plug the dedicated switch button into the rear 3.5mm
switch port. (This button can be used to turn the docking station on
and off, switch between PC1 and PC2 inputs)
3) Plug the power adapter of the docking station into the AC 110 V /
230 V mains and hold the ON button.
4) Plug the USB-C cable into the USB-C port on the back panel of the
dock
5) Plug the other end into an available USB-C or Thunderbolt
3/4 port on your device.
6) The automatic installation of ports on each system is then initiated.
7) After the installation is complete, restart your laptop/tablet.
In Windows, the LAN port appears in Start → Control Panel (View Small
Icons) → Device Manager → Network Adapters as "ASIX USB Ethernet".
Audio ports can be found in Start → Control Panel (View Small Icons) →
Device Manager → Audio, Video and Game Controllers as "USB Audio".
If one of these devices is marked with a yellow "! " or "? ", then the dock-
ing station is not installed correctly. In this case, disconnect the docking
station, uninstall the existing drivers (see the section „Uninstalling Driv-
ers") and reinstall the latest drivers, which are available for download on
our website www.i-tec.pro/en under the „Download" tab for this product.
Then reconnect the docking station to the laptop/tablet. In case of prob-
lems, you can contact our technical support: support@itecproduct.com.
12 |
ENGLISH
TM