Maintenance And Care; Spare Parts And Accessories - Flex SE 125 18.0-EC Notice D'instruction D'origine

SE 125 18.0-EC
– Switch on power tool again.
– Place electric power tool on the work
surface.
9. After work, switch off the electric power
tool.
Brush ring
The guard features a brush ring.
This ring has two functions:
– As the ring projects above the surface
of the sanding pad, it is the ring which
comes into contact with the work surface
first. As a result, the sanding pad is
brought parallel to the work surface
before the sanding tool comes into
contact with the work surface. This
avoids a sickle-shaped depression
caused by the edge of the sanding pad.
– The ring retains the dust until it is
extracted by the dust extractor.
If the brush ring is damaged or excessively
worn, it should be replaced.
A replacement brush set is available from
any FLEX customer service centre.

Maintenance and care

WARNING!
Remove the battery before carrying out any
work on the power tool.
Cleaning
WARNING!
Do not use water or liquid detergents.
CAUTION!
When cleaning with compressed air, always
wear goggles.
 Regularly clean the power tool and
ventilation slots. Frequency of cleaning is
dependent on the material and duration
of use.
 Regularly blow out the housing interior
and motor with dry compressed air.
 Regularly clean the filter cover.
 Remove filter cover and blow it out with
dry compressed air.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
NOTE
During the warranty period do not loosen
the screws on the motor housing.
Non-compliance will deem the guarantee
obligations of the manufacturer null and void.

Spare parts and accessories

Other accessories, in particular insertion tools,
can be found in the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
25