Description (Fig. 1) - Zeegma Sap Pro Manuel De L'utilisateur

Description (fig. 1)

1.
Feeder
2. Rotating screw
3.
Squeezing screen
4. Automatic cleaning module
5.
Tank
6. Juice outlet
7.
Pulp outlet
How to assemble the device
The device must be assembled on a flat and stable surface. The device must
not be plugged in when you are assembling it.
1. Place the rubber seal in the pulp outlet (fig. 2).
2. If you have difficulties with placing the seal, you can moisten it with
a bit of water.
NOTE! Before every use, make sure the rubber seal is properly placed.
3. Install separately packed plugs at the end of pulp and juice outlet (fig. 3).
See fig. 4:
4. Place the tank on the base and turn in a clockwise direction.
5. Put collecting rubbers on the sieve.
6. Insert the screen into the automatic cleaning module and then place
in the tank.
Rotate it so that arrows marks „
7. Insert the rotating screw inside the screen, gently press and rotate.
8. Place the feeder on the tank, rotate as much as possible in a clockwise
direction.
Arrows marks „
9. Plug in.
Control panel options (fig. 5)
Note: Do not insert many products at a time. Large number of products
may cause the charge tube or rotating screw to get blocked, which may
eventually block the device.
8.
9.
10. Base
11. Settings panel
12. Pusher
13. Cleaning brush
" contact at the tank and screen.
" must contact each other at the tank and screen.
Pulp tank
Juice tank
EN