Zeegma Sap Pro Manuel De L'utilisateur page 13

Assembly of salad accessories:
1. Place the mandrel to connect motor axle.
2. Put the tank on the base and rotate in a clockwise direction.
3. Insert the knife inside the tank.
4. Place the cover on the tank, rotate as much as possible in a clockwise
direction.
5. Connect to power supply.
How to clean and maintain
Cleaning before use:
1. Follow the tips presented in the manual to assemble the entire device.
2. Close the pulp and juice outlets with plugs (see fig. 10). Connect to
power supply.
3. Pour 500 ml of water and activate „squeezer washing" function on the
panel. The procedure will be completed automatically. Next remove
plugs and pour the water out.
Cleaning after use:
Before you start cleaning, unplug the device. The device must be cleaned
after every use.
1. How to clean a motor base
Do not immerse the motor base in water and do not clean under running
water. Use a soft and wet cloth. To clean cable and plug, use a soft cloth.
2. How to clean a rotating screw
Use a brush or wet cloth to clean the remaining pulp. The rotating screw
may be cleaned under running water.
3. How to clean other pieces of the set
Disassembled parts can be washed with pure water. Do not use dishwasher.
Do not dry pieces with a drier, for example. Remove pulp from the device
5 minutes after you finished squeezing at the latest.
After cleaning, dry parts and store in a clean place.
NOTE! Do not use detergents, such as solvent, diluter, bleach or other
chlorine- or benzene-rich agents. Do not use abrasive materials and brushes
with sharp tips.
The pictures are for reference only. The real design of the products may differ from the
pictures presented.
EN