Tools And Materials; Before You Begin - Kohler K-18829 Guide D'installation Et D'entretien

Tools and Materials

Assorted Drill Bits Silicone Plumbers
Grease
5/8"
(16 mm)
1/2"
1/4 turn, 1/2" NPT
Supply Shut-off with
5/8" or Shorter Handle

Before You Begin

IMPORTANT! 2x4 framing is required for this product.
IMPORTANT! In areas with freezing temperatures, install on an
interior wall. If installed on an exterior wall, provide adequate
insulation to prevent the possibility of freezing.
NOTE: If 2x6 framing is used, the drain outlet may be angled 45
degrees in either direction.
NOTE: This device is not intended to be used as a retrofit device
for 1.28 gpf (4.8 lpf) water closets.
NOTE: Performance may vary. This product was tested with toilets
that are listed as compatible.
Only bowl numbers K-6299 and K-6300 are compatible with the
carriage.
During installation, make sure the inlet tube connections and
gaskets remain fully engaged to ensure a watertight seal.
Carefully inspect the carriage and tank for damage.
Observe all local plumbing and building codes.
For Installations with a Bidet Seat
CAUTION: Risk of personal injury. If the optional electrical
outlet will be installed, it must be connected to a GFCI or
RCD protected circuit.
1246750-2-B
All manuals and user guides at all-guides.com
1/4" x 2" (51 mm) Min
Lag Bolts
Plus:
• Conventional woodworking
tools and materials
• 1/4" x 2" (51 mm) Min
Concrete Expansion Bolts
(for concrete subflooring)
Optional:
• Assorted electrical tools
2 Kohler Co.