Akai AMP-45 Manuel D'instructions page 9

1
1
2
STAN DB Y
3
BA SS
BA SS IR
4 FM ST .
5
6
/ SD
/
7
8
RE P./
PR O.
RA N.
MP 3/ CD AU X RADIO AM FM FM ST .
9
TU NI NG
10
11
12
SD MMC CA RD / US B
.POWER BUTTON
1
2.LCD DISPLAY
3.BASS BUTTON
4.VOLUME+ BUTTON
5.BACK BUTTON
6.PLAY/PAUSE/USB BUTTON
7.TUNING CONTROL
8.REPEAT/RANDOM BUTTON.
9.FUNCTION SELECT
10.CD DOOR
11.MMC/SD CARD
12.STEREO HEADPHONE JACK
13.CD DOOR OPEN/CLOSE BUTTON
27 28 29
26
30
1 2
/USB STOP SD /
9
REP./
3 4
- - RAN. + +
10/FOL 10/FOL
5 / / 6
7 VOL- PROG. VOL+ 8
10
-15-
All manuals and user guides at all-guides.com
13
14
15
16
17
18
19
20
21
22
25
23
24
14.STANDBY INDICATOR
15.BASS INDICATOR
16.REMOTE SENSOR
17.FM STEREO INDICATOR
18.STOP/SD BUTTON
19.NEXT BUTTON
20.VOLUME- BUTTON
21.PROGRAM BUTTON
22.BAND SELECTOR（AM·FM·FM ST.)
23.USB JACK
24.AUX IN JACK
25.AUX-IPOD JACK
26.LEFT&RIGHT SPEAKER BOXES
27.FM ANTENNA
26
28.SPEAKER WIRE CONNECTOR(R)
29.SPEAKER WIRE CONNECTOR(L)
30.AC MAINS
)/usb
1.Play/pause(
2.Stop/sd button
3. -10/FOL- button
4. +10/FOL+ button
5.Back( )/search( )
6.Next( )/search( )
7.Volume - button
8.Volume + button
9.Repeat/Random button
10.Program button
1.POWER BUTTON
-Press POWER button on
2.LCD DISPLAY
- show the AM/FM dial frequency
- show the number of tracks
3.BASS BUTTON
-to enhances bass response
4.VOLUME+ CONTROL
- adjust volume up level.
5.SEARCH BACK
- to select back track
- press and hold more than 1.5 sec BACK
search intra track
6.PLAY/PAUSE/USB BUTTON
- start or pause MP3/CD/USB/SD/MMC
play
- Press and hold more than 1.5 sec
change to CD/USB mode.
7.TUNING CONTROL
- select AM/FM/FM ST. Stations
8.REPEAT/RANDOM BUTTON
- repeat a track/CD/MP3/USB/SD
/MMC/program
RANDOM BUTTON
- play CD/MP3 tracks in random order
9.FUNCTION SELECT
- select source of sound MP3/CD,AUX,
or RADIO.
10.CD DOOR
11.SD/MMC CARD JACK
- To listen to your SD/MMC card
with Mp3 music files.
12.STEREO HEADPHONE JACK
- 3.5 mm stereo headphone jack.
13.CD DOOR OPEN/CLOSE BUTTON
- press here to open/close the CD door.
14.STANDBY INDICATOR
15.BASS INDICATOR
16.REMOTE SENSOR
17.FM STEREO INDICATOR
- show the FM stereo indicator
18.STOP/SD BUTTON
- stop CD/MP3/USB/SD/MMC playback;
erase a CD program.
-Press and hold more than 1.5 sec change
to MMC(SD)mode.
19.SEARCH NEXT
-to select nest track
- press and hold more than 1.5 sec
forward search intra track.
20.VOLUME- CONTROL
- adjust volume down level.
21.PROGRAM
-program and review programmed
track numbers.
22.BAND SELECTOR (AM·FM·FM ST.)
- select AM/FM/FM ST. wave band
23.USB JACK
To listen to your USB flash memory
stick with Mp3 music files.
24.AUX JACK
- Push FUNC button , select AUX station.
、 、
play
Mp3 DISCMAN WALKMAN AUX
.
insert when no disc
25.AUX-IPOD JACK
(The special of ipod connects )
- Push fuction button select AUX station,
play IPOD and supply power.
-After connecting audio equipment to the
AUX INPUT JACK,the IPOD will have
no funciton .
- The unit does not control the ipod.
26.LEFT&RIGHT SPEAKER BOXES
27.FM ANTENNA
- to improve FM reception
28.SPEAKER WIRE CONNECTOR(R)
29.SPEAKER WIRE CONNECTOR(L)
30.AC MAINS
- inlet for power cord.
REMOTE CONTROL HANDSET (See
~
1 10
The remote control buttons function is the same
as the button of CD/MP3 /USB/SD section .
Select the CD/MP3 tracks by (+10)/(-10) button.
-The remote control volume button no function
in the AUX or radio mode.
Install remote control battery
1. Open the battery cover to remove it.
2. Insert CR battery (not included) correctly so that
the + and - polarities match the polarity diagrams inside
the battery compartment.
Note:
* About half a year of normal operation can be expected
when using the general batteries.
* When the battery are exhausted, the commander
should no longer operate the system. Replace it a new on
* When the commander is not to be use for a long time,
remove the battery to avoid damage caused by
battery leakage and corrosion.
* Avoid keeping the commander in extremely hot or humid
locations.
* Between remote controller and remote sensor there sho
be no obstacle and have to within 30 range.
* The remote controller s operating distance is about 0.2M
6M away from the remote sensor.
-16-
)