Product Description; Control Panel - IKEA BEMOTA 903.893.36 Mode D'emploi

ENGLISH

Product description

Control Panel

BUTTON FUNCTION
A =
Turn the motor on/off at speed one. Turn off each speed.
Speed
Turn the motor on at speed two / Activate charcoal filter alarm
Pres and hold the button for approximately 2 seconds, with all the loads turned off (Motor+Lights), to turn the
B =
Activated Charcoal Filter alarm on. LED (A) flashes twice to confirm.
Speed
To Deactivated Charcoal Filter alarm off, press the button again and hold for at least 2 seconds.The relevant
LED flashes once (A). Only for recirculation mode. (please refer to page 7)
Turn the Motor on at speed three / Reset alarm grease and charcoal filter saturation
C =
Pres and hold the button for approximately 2 seconds, with all the loads turned off (Motor+Lights),
Speed
to reset the grease and charcoal filter saturation alarm. LED (A) flashes three times.
Turn the motor on at Booster speed.
D =
This speed is timed to run for 6 minutes. At the end of this time, the system returns automatically to the speed
Speed
that was set before. If it is activated with the motor turned off, it will switch to OFF at the end of the time. To
deactivate it, press button D or press button A
E =
Pres briefly: Turn the lighting system on and off at maximum intensity.
Light Pres and hold to change the lighting intensity up or down.
A B C
Upper chimney
Lower chimney
Hood body
LED Lighting
Grease filter
Control panel
D E
8