Normal Playback - AudioSonic HF-1250 Mode D'emploi

Fm / Fm-stereo reception
• S et the "BAND" selector to FM mode for MONO reception.
• S et the "BAND" selector to FM ST. mode for FM STEREO reception.
The Stereo indicator light up to show FM ST. mode.
For better reception
• F M - This appliance has a FM antenna located at the rear cabinet.
This wire is completely unraveled and extended for better reception.
• A M - This appliance is equipped with a built - in directional ferrite AM antenna.
Rotate the appliance to get better reception.
OPERATION
General operation
This product is equipped with an auto power-save function at the Cd mode. if the
unit remains in SToP, PaUSE or No diSC mode for more than 10 minutes it will
automatically switch off. To switch the unit back on, slide the FUNCTioN switch to
'oFF' position and then back to Cd again.
PLaY / PaUSE ( ) Press to start playing Cd disc.
Press again to stop playing Cd operation temporarily.
Press again to resume playback.
SKiP + & ( ) Press to go to the next track or back to the previous track.
SKiP - ( ) Press and hold while playing until you find the point of
the sound.
SToP ( ) Press to stop all Cd operation.
Playback
• Set the "FUNCTioN" selector to "Cd" mode.
• open the Cd door and place a Cd disc with the label up in the Cd compartment.
• Close the Cd door.
• Focus search is performed if disc is inside. Total number of tracks is read and
appears on the display.
• Press the "PLaY / PaUSE" button to start playing Cd disc.
• adjust the "VoLUME" control to the desired level.
6
All manuals and user guides at all-guides.com
instruction Manual
• Press the "PLaY / PaUSE" button again when you want to stop playback
temporarily.
• Press the "SToP" button when finished.
OPERATION
Program
Up to 20 tracks can be programmed for disc play in any order.
Be sure to press the "SToP" button before use.
• Press the "PRoGRaM" button, the display will show "00" and flash.
• Select desired track by using the "SKiP +" or "SKiP -" button.
• Press the "PRoGRaM" button again to confirm desired track into the program
memory.
• Repeat step 2 and 3 to enter additional tracks into the program memory.
• When all the desired tracks have been programmed. Press the "PLaY / PaUSE"
button to play the disc in the order you have programmed and the program
indicator flashes.
• Press the "SToP" button once to terminate programmed play and the program
indicator will turn off.
• The program indicator does not flash after setting up programmable play.
Repeat
Press the "REPEaT" button before or during playing Cd, a single track or all the tracks
can be repeated. Each press switches the repeat mode as follows:
1 - REPEaT 1 ( The repeat indicator is flashing. )
2 - REPEaT aLL ( The repeat indicator is steadily on. )

3 - NoRMaL PLaYBaCK

1. . 1. 1.