Starting A Wash Cycle - Black & Decker BPD8W Manuel D'instructions

SET UP & USE

STARTING A WASH CYCLE

1. Pullout the dishwasher racks, load the dishes and push the racks back in.
2. Add Detergent and Rinse Aid as needed.
3. Insert the plug into the socket. The power supply is 120V/60 Hz.
4. Make sure that the water supply is turned on to full pressure.
5. Close the door and press the POWER button to turn on the dishwasher
6. Choose a wash program and the corresponding indicator light will turn on.
7. Press the Start/Cancel button, the dishwasher begins to start.
NOTE: When you press the Start/Pause button to pause during washing, the display
time will stop blinking and the program will pause and remain this cycle till you
restart it again.
Page 20