Rinse Aid Dispenser - Black & Decker BPD8W Manuel D'instructions

SET UP & USE

RINSE AID DISPENSER

Rinse Aid improves drying, eliminating spots and streaks on your glasses and dishes.
It is automatically released during the final rinse to prevent water from forming
droplets. The rinse aid dispenser is located inside the door next to the detergent
dispenser.
WARNING: Only use branded rinse aid for dishwasher. Never fill the rinse aid
dispenser with any other substances. (Examples: Liquid Detergent or other soap).
This would damage the appliance.
REFILLING THE RINSE AID DISPENSER
When the Rinse Aid symbol is illuminated on the control panel, it indicates that the
rinse aid dispenser requires a refill.
If the rinse-aid warning light in the control panel in not illuminated, you can check the
amount of rinse-aid in the dispenser by the color of rinse aid indicator next to the cap.
When the rinse-aid dispenser is full, the circular indicator will be dark. As the rinse-aid
diminishes, the size of the dark circle decreases as shown below. You should never let
the rinse aid get below 1/4 full.
Full
To fill the dispenser:
1. Remove the rinse aid reservoir cap by rotating it counterclockwise.
2. Carefully pour in the rinse-aid into its dispenser, while avoiding overflow.
3. Close the rinse aid reservoir cap by rotating it clockwise.
Note: clean any spilled or excessive rinse aid to avoid excessive foaming when the
dishwasher is in use.
The rinse aid dispenser has four settings. "1" selects the smallest amount or rinse aid,
while "4" releases the largest amount of rinse aid that is released during the rinse
cycle. The recommended setting is on "3". If the dishes still are not drying properly
or are spotted, adjust the dial to a higher number. If there are sticky white stains or a
bluish film on glassware or silverware adjust the dial to a lower setting.
Page 14
Rinse Aid Indicator
3/4 full 1/2 full
Rinse Aid
Reservoir Cap
1/4 full Empty