IKEA DJUPFRYSA Serie Mode D'emploi page 15

ENGLISH
Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the Fast Freezing,
or after changing the tem-
perature.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
All manuals and user guides at all-guides.com
Possible cause
The Fast Freezing function
is switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
This is normal, no error has
occurred.
The Fast Freezing function
is switched on.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
The thickness of the frost is
greater than 4-5 mm.
The door has been
opened often.
The Fast Freezing function
is switched on.
There is no cold air circula-
tion in the appliance.
Solution
Refer to "Fast Freezing func-
tion".
Refer to "Closing the door".
Wrap the food products bet-
ter.
Refer to "Operation" chapter.
The compressor starts after a
period of time.
Switch off Fast Freezing man-
ually, or wait until the function
resets automatically to set the
temperature. Refer to "Fast
Freezing function".
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Defrost the appliance.
Open the door only if necessa-
ry.
Refer to "Fast Freezing func-
tion".
Make sure that there is cold
air circulation in the appliance.
15