Echo CS-370 Manuel D'instructions page 16

Ignition switch
Start / Run
Push
Throttle latch
Starter handle
Unlock chain brake
Choke control knob
Open choke
Unlock chain brake
CS-370
All manuals and user guides at all-guides.com
Chain brake
Throttle trigger lockout
Throttle trigger
WHEN THE ENGINE IS HARD TO
START
CAUTION
Make sure the bar and chain are free from any
obstruction when starting the chain saw.
• Move chain brake lever fully forward to lock chain brake
before starting.
• Press throttle trigger lockout down while grasping throttle
trigger and push in throttle latch.
• Move ignition switch to "RUN" position.
• Securely hold the chain saw as shown and pull starter
handle.
• When engine starts, immediately squeeze throttle
trigger, to release throttle latch.
CAUTION
1. When using throttle latch for starting, keep the
brake in lock position.
2. After starting the engine, squeeze throttle
trigger slightly to release throttle latch.
3. Do not increase engine speed while chain brake
is locked.
CAUTION
The chain will attempt to rotate when engine is
started with throttle latch engaged. After engine
starts, release throttle trigger to idle engine,
otherwise brake damage may occur. Never use
throttle latch for cutting. Use it only when starting
the engine.
WHEN THE ENGINE IS WARM
• Move chain brake lever fully forward to lock chain
brake before starting.
• Confirm there is fuel and chain oil in the tanks.
• Move ignition switch to "RUN" position.
• Securely hold the chain saw as shown and pull starter
handle.
• Choke may be used if necessary, but be sure to push
it back on first firing sound.
NOTE
If engine does not start after 5 pulls, use cold start
procedure.
16