Assembly And Operation; Eg- Declaration Of Conformity - Redwell Rollingwave/Rondo 500 Mode D'emploi

Redwell
BEfoRE thE initiaL staRt-uP
Read the safety instructions and the manual before use! Check the
voltage information on the type plate (top side). if you notice damages on the element, do not use it - contact your specialist dealer.
we recommend you not to throw away the original package of the device. store the original package for possible transport.

assEmBLY anD oPERation

device
The has to be installed by an installation specialist with the delivered assembly kit on the ceiling at least 3 m high - outside the contact area - and
connected to the mains system taking into account the appropriate standards and norms of the country concerned.
Height, outside the contract
area, at least 3 m
Rollingwave/Rondo and diskus
PossiBLE DisoRDERs & PossiBLE causEs
disORdeR
The heater does not get warm.
if you have checked all the causes mentioned above and the infrared heating element is still not operating, please contact the service center or your
installation specialist.

Eg- DEcLaRation of confoRmitY

The Redwell Manufaktur gmbH declares that this device is conform with the eMC regulation eMV 2004/108/eg and
with the low-Voltage directive 2006/95/eg.
designates that failure to comply with these can endanger your health and/or the function of your infrared heating element.
designates, that the infrared heating element is conform to the european directive 2002/96/eg.
The appropriate disposal and collection of scrap equipment serve to prevent potential environmental and health damages.
They are a requirement for the re-use and recycling of used electric and electronic devices.
designates further information and tips.
designates that the infrared heating element must not be covered.
8 - gb
device
for visible damage and whether the mains voltage is in accordance with the
Causes
There is no power to the device.
The fuse has blown or circuit breaker has
tripped.
HelP
Check the power is connected correctly and the
thermostat is wired and programmed correctly
Check the fuse and circuit breaker and make sure
that the total load on the circuit does not exceed the
circuit rating.