Room Thermostat; Glass Panel Holders For Ceiling Installation; General Warranty Terms - Olsberg Orayonne Notice D'utilisation

Room thermostat

To use the glass panel heater for room heating purposes, it can be equipped with a room thermostat
that is available in two models:
Room thermostat with cable connection parts no.: 15/2381.9270
Wireless room thermostat
The room thermostat features the following functions:
•
Large LC display with blue backlit screen
•
Week programming
•
Operating modes: Automatic / Comfort / Reduction / Frost protection / Off
For more information on the room thermostats, see enclosed separate manual.
The receiver of the wireless room thermostat must be installed behind the radiation heater. For possible
installation positions, see drawings in chapter "Distances for attachment of wall bracket".
Caution: Wireless room thermostats cannot be used for radiators installed with rear panel hiders.
For wiring diagrams of wireless room thermostats and thermostats with cable connection, see chapter
"Electrical connection".

Glass panel holders for ceiling installation

Glass panel holders made in brushed stainless steel,
parts no.: 15/2381.9290
When the heater is installed on the ceiling the glass panel must
be secured with additional holders for safety reasons. The glass
panel is attached to the rear panel of the appliance with a
specially developed adhesive with high thermal resistance and
mechanical strength. To ensure that the glass panel does not fall
down in the unlikely event of becoming dislodged, install the four
glass holders.
Installation:
Slide the four holders from the side over the glass and the rear
panel of the appliance and secure them with the enclosed sheet
metal screws from the rear of the panel (see Fig.11).

General warranty terms

Dear customer
In guarantee case the country specified rights are valid which you may claim directly towards your
dealer.
parts no.: 15/2381.9260
Fig. 11
35