Table des Matières
Publicité
22
Installation du FIREPLACE INSERT(pour installateurs qualifiés seulement)
Insert avec une
connexion directe
(foyer de Z.C.)
REMARQUE:
Diriger les connexions
nécessitent l'installation
d'une plaque de bloc-off
étanche à l'air ou
adaptateur amortisseur
(voir « bloc-off plaque
Installation » page
Error! Bookmark not
defined.).
Insert avec
connexion de
sceau de visage
REMARQUE:
Visage sceau
connexions nécessitent
l'installation des
panneaux surround et
isolant (voir « Entourent
Panel Installation »
page Error! Bookmark
not defined.).
© Travis Industries
NOTE: This installation may be
used with a masonry or zero
clearance fireplace. This
illustration depicts a zero
clearance insert, all requirements
in the section "Zero Clearance
Fireplace Requirements" must be
fulfilled prior to installation.
Combustible Mantle
Surround Panels
See the section
"Insert Placement
Requirements" for
minimum clearances
and hearth required.
Telescoping Legs
NOTE: This installation may be
used with a masonry fireplace
only. The requirements in the
section "Masonry Fireplace
Requirements" must be fulfilled
prior to installation.
Flue
Liner
Combustible Mantle
Surround Panels with
insulation (see "Surround
Panels" installation
instructions in the back of
the manual)
See the section "Insert
Placement Requirements"
for minimum clearances
and hearth required.
Optional
100-01166
Stainless steel
chimney connector
must Extend 1' past
the block-off plate.
Damper must
be removed
Block-off plate or
damper adapter
Z.C. (Metal) firebox
No modification to the firebox
of the z.c. fireplace is allowed.
NOTE: It is
recommended your
chimney have a
minimum 28 and a
maximum of 144
square inch cross-
sectional area to use a
face seal connection,
otherwise your
chimney maynot have
sufficient draw for the
fireplace insert to
operate correctly.
Airtight Insulated
Clean-Out
Remove damper
or wire it open
4040907
Publicité
Table des Matières
