Understanding Your Reading - Tanita UM-041F Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

UNDERSTANDING YOUR READING

Healthy Range Indicator
Your body fat monitor/scale automatically compares your body fat reading to the
Healthy Body Fat Range chart.
Following your body fat percentage reading, a black bar will flash along the bottom
of the display, identifying where you fall within the Body Fat Ranges for your age and
gender. For example, if the squares appear above (0) area your reading is within the
Healthy Range – if they appear over (-) area, your reading is below the Healthy Range.
For more about the Healthy Range, see page 2.
(-) : Underfat; below the healthy body fat range. Increased risk for health problems.
(0) : Healthy; within the healthy body fat percentage range for your age/gender.
(+) : Overfat; above the healthy range. Increased risk for health problems.
(++) : Obese; high above the healthy body fat range. Greatly increased risk of obesity-related health problems.
TROUBLESHOOTING
If the following problems occur ...then...
• A wrong weight format appears followed by kg, lb, or st-lb
Refer to "SWITCHING THE WEIGHT MODE" on p. 5.
• "Lo" appears on the display, or all the data appears and immediately disappears.
Batteries are low. When this message appears, be sure to replace the batteries immediately, since weak batteries will affect the
accuracy of your measurements. Change all the batteries at the same time with new AAA-size batteries.
Note: Your settings will not be erased from the memory when you remove the batteries.
• "Error" appears while measuring.
Please stand on the platform keeping movement to a minimum.
The unit cannot accurately measure your weight if it detects movement.
• The Body Fat Percentage measurement does not appear or "-----" appears after the weight is measured.
Your personal data has not been programmed. Follow the steps on p. 6.
Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned with the guides on the
measuring platform.
• "OL" appears while measuring.
Reading cannot be obtained if the weight capacity is exceeded.
• "Error %" appears while measuring.
The Body Fat Percentage is more than 75%, readings cannot be obtained from the unit.
Specifications
Weight Capacity
150 kg (330 lb) (23 st 8 lb)
Weight Increments
0.1 kg (0.2 lb) (0.2 lb)
Body Fat Increments
0.1%
Personal Data
4 memories
Power Supply
4 AAA batteries (included)
Power Consumption
60 mA maximum
Measuring Current
50 kHz, 100 µA
8
Notice:
These marks can be found out on contaminant-containing
Batteries: Pb Pb = Battery contains lead,
Cd Cd = Battery contains cadmium,
Hg Hg = Battery contains mercury.
Not allowed to mix batteries with consumer
wastes!
As consumer you are legally bound to return used or discharged batteries.
You can deposit your old batteries at the public collecting points in your
town, or wherever the corresponding batteries are sold and specifically
marked collecting boxes have been set up. In case of scrapping the
apparatus, the batteries should be removed from it and deposited at the
collecting points as well.
The device features radio interference suppression in
compliance with EC regulation 2004/108/EC
Note: Range of user age is between
18-99.

Publicité

Table des Matières
loading

Table des Matières