Haojue HJ125-8 Manuel D'utilisation page 53

(52) Haojue HJ125-8 99011H30220H000 V02 EN+FR 2015-3-2
Tires
•
Inflate the tires to the pressure recommended in this
manual.
Exterior
•
Spray all rubber parts with a rubber protective agent.
•
Spray all paint-free surfaces with an anti-rust agent.
•
Coat the paint surface with vehicle wax.
Procedures for motorcycle re-service
•
Clean the motorcycle completely.
•
Re-install the battery.
EN
NOTE: Connect the wire to the positive terminal first; then
the negative terminal.
•
Remove the spark plug.
times, and then mount the spark plug.
•
Adjust tire pressure according to the instructions in the
tire section.
•
Lubricate according to the instructions in the
lubrication section.
•
Be sure to conduct necessary inspections according
to this manual before riding.
(52) Haojue HJ125-8 99011H30220H000 V02 EN+FR 2015-3-2
All manuals and user guides at all-guides.com
Start the engine several
50
NOTICE OF BATTERY USAGE
1. ACTIVATION OF NEW BATTERY
1.1 Addition electrolyte
1.1.1 Check the appearance of the battery and make sure
there are no scratches and cracks, the terminals should
not be slanting or deformed.
1.1.2 Take off the sealed rubber cap of the air outlet, take
off the vent plug.
1.1.3 Take out the special battery electrolyte provided with
the battery, cut off the electrolyte container cap, put a
plastic tube to fill electrolyte slowly, till the liquid level
reached the upper level, put it aside for 20 minutes after
adding electrolyte. If the liquid level drops, replenish till
the upper level. Note: Please do not exceed the upper
level mark.
1.1.4 Thirty minutes after adding electrolyte, the engine
can be started. If conditions permit, recharge for 3–
5 hours before riding, which will further improve startup
performance and extend the battery life. In winter when
the temperature is low or after long periods of storage, the
battery should be recharged for 3–5 hours before using.
1.1.5 Close the filling hole plug tightly, rinse away any
electrolyte outside the battery with clean water, use cloth
to wipe it clean.
1.2 Installation
1.2.1 Put the air outlet onto the nozzle, make sure
that the pipe is not distorted or crushed, otherwise
the battery might explode. If any electrolyte is spilt