Light Bulb Replacement; Ice Cube Tray - Danby DFF091A1WDB Guide D'utilisation Et Soins De Propriètaire

Installation Instructions
DOOR REVERSAL
INSTRUCTIONS
1) To access the lower hinge assembly, tilt back the refrigerator (Fig.
A).
2) Remove both leveling legs located at the front of the unit.
3) Remove the screws holding the lower hinge assembly to the unit.
4) Remove the main door assembly from the refrigerator
(lift open door slightly and pull downward).
5) Using a flat head screwdriver, remove the main door top
hinge pin (Fig. B).
6) Re-install the main door top hinge pin on the opposite side of the
unit.
7a) Remove the door plug and door bushing located on the top of the
main door.
7b) Interchange their positions (eg. door plug right side, door bushing
left side).
8) Re-install main door assembly on the refrigerator.
9) Remove door bushing (bottom door) and install on opposite side.
10) Re-install the lower hinge assembly on the opposite side.
11) Make sure the door assembly is properly aligned on the unit before
tightening lower hinge screws.
12) Re-install both leveling legs.
The process is now complete.
LIGHT BULB
REPLACEMENT
To replace the refrigerator light bulb:
1. Remove the screw from the light bulb cover.
2. Pull the light bulb cover downward.
3. Unscrew the bulb.
4. Replace with a standard 40 watt appliance bulb only.
ICE CUBE TRAY
The ice cube tray is flexible. Twist tray to remove the ice cubes. If the ice cube
tray is frozen solid, run a little water over the tray. Never use a knife or other metal
instruments to remove the ice cube tray from freezer compartment, as this may
damage the evaporator.
Fig.c
4
Fig.B