CASUALPLAY Vintage 3 Mode D'emploi page 17

UNISYSTEM (illustrations 26-28)
This exclusive fastening system means that the following accessories can be used on
the Vintage 3 pushchair: Prima, Prima Fix, Baby Zero Plus, Playmoon, Mako and
Metropol Carrycot.
The procedure for fitting all of them is the following:
• Put the parking brake on.
• Place the Prima, Prima Fix, Baby Zero Plus, Playmoon, Mako or Metropol Carrycot
on the pushchair, facing backwards.
• Line the fasteners of the Prima, Prima Fix, Baby Zero Plus, Playmoon, Mako and
Metropol Carrycot up with their slots (fig.26).
• Press downwards until it clicks indicating it is fastened and a green signal appears in
both of the windows on the sides of the fasteners (fig.27).
• To remove, press and then release the red button on both fasteners (a red signal will
appear in the window) and pull upwards to release the accessory from the chassis of the
pushchair (fig.28).
WARNING: The Vintage 3 can be folded without the seat or with the seat facing forwards.
It can not be folded with the accessories installed or with the seat facing backwards.
FOLDING (see illustrations 29-32)
• Slide to the left (A), press the folding button (B) (fig.29) and at the same time, move the
safety catch upwards (fig.30). Push the handlebar forwards (fig.31).
• Completely fold the chassis and check that the locking device (red) has secured the
chassis to prevent it from accidentally opening (fig.32).
BASKET
• The basket is clipped onto the lower part of the chassis, to remove it simply undo the
clips and take it off.
• The maximum weight that the basket can hold is 2.5 kgs.
• It is advisable to empty the basket before folding the pushchair.
MAINTENANCE
• From time to time grease the mobile parts with a lubricating product (not grease or oil).
• Inspect the brakes, harness, clips and mechanisms that may become loose or suffer
from wear and tear through use.
• Clean the chassis with a damp cloth (never use abrasive products or solvents). Use a
sponge with warm water and mild detergent on the plastic parts.
• Follow the washing instructions for the fabric parts of the pushchair, let them dry fully
before folding the pushchair. Do the same if the pushchair has been exposed to damp
conditions to prevent mould from forming.
• Do not use accessories that have not been approved by the manufacturer.
All manuals and user guides at all-guides.com
15