Appliance Installation - Stiebel Eltron MINI-E 2-1 Utilisation Et Installation

INSTALLATION

10.2.2 Appliance installation

Note:
 Mount the appliance on the wall. 
The wall must have a suffi cient load-bearing capacity for
the weight of the device.
1 Undo the cover screws by two turns.
2 Undo the snap fastener using a screwdriver.
3 Remove the appliance cover with the heater towards the front.
10 | MINI ™ -E SERIES TANKLESS ELECTRIC WATER HEATERS
1
1 Knockout for hard-wiring
 Using pliers, break out the knock-out for the power cable in the 
appliance cover. Correct the contours with a fi le if necessary.
 Use the appliance back panel as a drilling template. 
 Secure the appliance back panel to the wall with suitable plugs 
and screws.
WWW.STIEBEL-ELTRON-USA.COM