Factory Reset; Trouble Shooting; Disposal Instructions - Danfoss Link FT Mode D'emploi

Installation Guide

Factory reset

Trouble shooting

Green LED ON
Red LED ON
Green LED fast flash
Red LED short flash
RED LED slow flash

Disposal instructions

10
Danfoss Link™ FT
1 . Turn off power on the safety switch
on the front .
2 . Hold the install button in while
pushing ON the safety switch and
keep the install button pressed
until the LED gives a red flash (ap-
prox . 5 sec . )
Standby
Heating
Inclusion or link test
Inclusion not OK, goes to not
included .
Linktest not OK, goes to
missing link
Sensor failure
VISGZ45X © Danfoss 04/2011