Waeco CoolAir CA-1000-AC Notice De Montage Et D'utilisation page 37

_CA-1000.book Seite 37 Freitag, 28. Juli 2006 10:35 10
CoolAir
5.2.2 Installation in an existing sunroof opening
Existing roof hatch openings of 400 to 435 mm are suitable for the
installation of the roof air conditioner.
WAECO International only assumes liability for parts included in the scope
of delivery. The validity of the warranty expires if the device is installed
together with third-party parts.
Please observe the structural engineering of the vehicle and seal of all
openings made when installing the roof air conditioner.
Removing the roof hatch
➤ Remove all screws and fixtures of the existing roof hatch.
➤ Take out the roof hatch.
➤ Remove the sealant around the opening using a scraper or similar tool
(see fig. 3 on page 3).
➤ Use a sealant to seal the bore holes (see fig. 4 on page 4).
Dispose of all waste material, glue, silicone and seals separately. Observe
the disposal guidelines.
5.2.3 Laying the power cable
– see fig. 7 on page 5 –
Make sure there is no voltage at electrically operated components before
carrying out work on them!
➤ The roof air conditioner must be connected to an electric circuit which
is able to supply the required current.
All manuals and user guides at all-guides.com
Installation
37