Displaying Alarm Settings; Snooze; Sunrise Simulator; Starting A Sleep Cycle - Verilux Rise & Shine VA05F Mode D'emploi

Operating Instructions — continued
2. Select by pressing the Back
repeatedly. Press the
icon will flash.
3. When the Sleep icon is chosen, the lamp brightness will increase to the last
level set. Use the Back
final brightness level for the Sleep Cycle.
• Press the

Displaying Alarm Settings

Press the button repeatedly to cycle between displaying:
Alarm
• AL1 – Alarm 1 Setting
• AL2 – Alarm 2 Setting
• Both Alarms

Snooze

When the alarm sounds, you may press down on the top of the
Rise & Shine – as you would a button – to Snooze.
®

Sunrise Simulator

Beginning 15 minutes before the alarm set time, the light will
gradually increase in intensity to simulate sunrise. There are 20
possible light levels. The final brightness level, which may be any
level between 1 and 20, is set as described on page 12 under Setting the Alarm
and Sleep Cycle Brightness.

Starting a Sleep Cycle

A sleep cycle simulates diminishing sunset lighting by beginning with the lamp on
maximum brightness, or the highest brightness you previously set, with the light
progressively dimming for the duration of the cycle until the lamp is off at the end
of the cycle.
You may start a sleep cycle whenever you wish:
• Press the
Sleep
• The minutes remaining in the sleep cycle are shown on the display.
• Press the
Sleep
• To manually end the Sleep cycle, press the
repeatedly until you reach "00". You will need to manually turn the lamp and/or
radio on, if you wish to do so.

Display Dimmer

To adjust the LCD display brightness to Off, Normal or Bright setting, press the
button repeatedly for the desired brightness.
Display
button to confirm the desired selection. The chosen
Set
button or the Forward
button to confirm.
Set
button to begin a sleep cycle.
button repeatedly to choose 0, 5, 15, 30 or 60 minutes.
button or the Forward
Button, or press the
Off
13
button
button to set a new
Press to
Snooze
Sleep
button