Carton Contents; Tools Needed For Assembly; Assembly; Grounding The Generator - Sears CRAFTSMAN 919.670031 Manuel

CARTON CONTENTS

NOTE: Left and right describes the location of a part
with the operator facing the outlet panel.

TOOLS NEEDED FOR ASSEMBLY

1 - Box Cutter or Knife
REMOVE GENERATOR FROM CARTON
• Open carton from top.
• Cut carton along dotted lines.
• Remove all carton inserts.
• Remove generator through opening in carton.
IMPORTANT: Before any attempt to start your genera-
tor be sure to check engine oil (See Adding Engine Oil
paragraph in the Operation section on page 12 of this
manual.)

ASSEMBLY

1 - Generator
Read owner's manual. Do not attempt to operate equipment until you have read Owner's
Manual for Safety, Assembly, Operation, Maintenance, and Storage Instructions.

GROUNDING THE GENERATOR

A grounding lug is supplied with the generator for use
when required by local electrical ordinances. Refer to
article 250 of the National Electrical Code to clarify
any needed grounding information. Your local electric
company or a certified electrician should be able to
help you with this information.
NOTE: Your engine is already grounded to the frame
by a grounding strap.
9 — ENG
1 - Owner's Manual
Grounding Lug
D20346 Rev. 0 2/28/00