Charging Intelligent Pump (C); Assemble Your Pump - weewell WPB 820 Mode D'emploi

All manuals and user guides at all-guides.com
II - Charging Intelligent Pump (C)
Intelligent pump parts must be charged before usage. When charging the breast pump,
there will be a red light. After the device is fully charged, light is turned off and the device
is ready to use. A fully charged device can be used for 2,5 hours.
III - Assemble your pump
Please wash your hands before assembling your breast pump.
1.
Insert the Breast shield (Silicone Massage Pad) (a) into the Shield Brace (b)
2. Place the Shield Brace (b) into the pump body (d) by rotating gently to
clockwise direction until it is securely in place.
3. Place the Valve (e) into the pump body (d), being sure that it fits securely
around the edge. ( Important! When the valve is lost or not properly installed,
the breast pump will not be able to use effectively)
4. Insert the feeding bottle (f) into the pump body (d) by rotating it gently to
clockwise direction, be sure that it fits securely into the pump body thread.
5. Insert the Intelligent Pump (C) into the pump body(d), breast pump can be
used then.
6. To make the breast pump stand firmly, insert the feeding bottle into the base.
IV.
I
8
WPB 820 USER MANUAL