Faults Table - ETNA KCV178NRVS Mode D'emploi

FAULTS

Faults table

When you have any doubts about whether your appliance is working properly you should not
immediately assume that it is defective. We recommend that you should in any case check the
points in the following table.
Symptom
The appliance emits a slight
odour.
The appliance does not
operate; the lighting does not
go on.
Temperature inside appliance
too high or too low.
Appliance makes a noise.
The LED lighting does not
work.
Excessive ice formation in the
freezer.
EN 30
Possible cause
New appliance.
Plug not in socket.
Thermostat off.
Thermostat setting incorrect.
The door seals are dirty or
damaged.
Incorrect positioning of food
in the freezer.
There is an object against the
appliance.
LED lighting defective.
The door has been opened for
too long or too frequently.
The door is not closed
properly.
The door does not seal
properly (the seal is dirty, the
door is misaligned or the seal
is damaged, etc.).
Solution
This is normal and disappears
when the appliance starts
cooling.
Insert the plug in the socket.
Adjust the thermostat to the
correct setting.
Adjust the thermostat
properly.
Clean the door seals.
Call the service centre if the
door seals are damaged.
Place foods in the proper
manner in the freezer.
Remove the object.
Consult a service technician
about LED lighting that is not
working. For safety reasons,
you are not allowed to repair
LED lighting yourself.
This product contains a light
source of energy efficiency
class F.
Make sure that the door is
closed properly.
Make sure that the door is
closed properly. Clean the
door seals. Call the service
centre if the door seals are
damaged.