Publicité
Les langues disponibles
Les langues disponibles
C. Replacing the Fuses (see figure 8)
To avoid electrical shock or arc blast, or personal injury or damage to the Meter,
Warning!
To replace the Meter's fuse:
1. Disconnect the connection between the testing leads and the circuit under test, and remove
the testing leads away from the input terminals of the Meter.
2. Turn the Meter to OFF position.
3. Remove the screws from case bottom, and separate the case bottom from the case top.
4. Remove the fuse by gently prying one end loose, and then take out the fuse from its bracket.
5. Install ONLY replacement fuses with the identical type and specification as follows and make
sure the fuse is fixed firmly in the bracket.
Fuse 1:500mA 250 V, fast type, Ø5x20mm.
6. Rejoin the case bottom and case top, and reinstall the screw.
Replacement of the fuses is seldom required. Burning of a fuse always results from improper
operation.
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the device being
incorrectly used or, applied for a purpose for whith it was not intended.
According to Waste Electrical and Electronic Equipment directive (WEEE), these ones must
be collected and arranged separately. If you have to throw them out, please, do not use the usual
rubbish. Please, contact your distributor for free recycling.
The maker guarantees to the device owner 12 months against any manufacture defect.
This guarantee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly filled
within one week after purchased the machine to the maker.
All manuals and user guides at all-guides.com
use specified fuses ONLY in accordance with the following procedure.
NOTES
GUARANTEE
29
Publicité
Chapitres
