Training Tips - Innotek UltraSmart IUT-300E Mode D'emploi

Masquer les pouces Voir aussi pour UltraSmart IUT-300E:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
IUT-300E Manual
1/19/05
Compliance with US FCC and European Telecommunications
Regulations
This INNOTEK
®
Remote Training System is designed to meet
worldwide requirements for telecommunications compliance.This
system contains both receiver and transmitter devices. In the US,
each transmitter device complies with Part 95 and/or Part 15 of
the FCC rules; each receiver device complies with Part 15 of the
FCC rules.
Each device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation. Each device may display indications as to
where this system is compliant worldwide. Note that in some
countries, the use of this INNOTEK
be limited due to national frequency planning requirements, and
the user is always responsible for respecting national and local
rules before operating.

Training Tips

• Watch the included DVD to get the basics for training your
dog properly with a remote trainer.
• We recommend your dog be at least six months old before
starting a remote training program.
• Always praise your dog for good behavior!
• Teach him what the commands mean before introducing the
collar as a reinforcement tool.
• Keep training sessions brief, about ten minutes of training
and then a rest or play period of at least equal length.
• Dogs learn through repetition. You may have better training
success if you can elicit an undesired behavior when you can
anticipate it. For example, if the dog misbehaves and jumps
on visitors, have someone come in and out of the front door
several times over a half-hour period. You'll be expecting it
and will be ready to teach your dog the right behavior.
7:15 PM
Page 9
®
Remote Training System may
Collar Status Indicators
Status Light
Alarm Tone
Pulsating Green
Duration of Tone
button press
Pulsating Red
Duration of the
Stimulation
Continuous
No tone
Green
Blinking Green
No tone
Blinking Amber
No tone
Blinking Red
No tone
After Removing From Charger
Continuous
No Tone
Green/Amber/Red
Continuous Red
20 sec
While on Charger
Solid Red
No Tone
Solid Green
No Tone
No Light
After Turning Collar ON
Blinking Amber
Blinking Green
Click; 5 consecutive
clicks for confirmed
fit
• Always end a training session on a positive note. Let the dog
have success. This way he'll look forward to the next session.
• Training should be fun for both you and your dog. Never train
when you are angry. If you get frustrated during training, stop
and come back to it later. Your dog will learn better when you
are both relaxed.
7
Condition
Tone only – no
stimulation
Stimulation being
delivered
Over-stimulation
warning; collar locked
for 10 sec.
Collar battery 60%
strength or better
Collar battery 60-20%
strength
Collar battery less than
20% strength; charge
immediately
Battery strength
(see above)
Self-test failure; unit is
not operational
Charge in progress
Charge complete
Charge failure
Unit is in ReadyFit
mode for 90 sec after
turning on
ReadyFit mode
indicates collar is
making true contact
with dog's skin

Publicité

Table des Matières
loading

Table des Matières